Sunday, February 17, 2008

More off than on !

That is bodywork wise anyway. Another glorious weekend and I set too removing the rear wing. I debated long and hard about removing it. I have the cash to buy a new outer sill and new wing ( left over from x-max prezzies) and i have in the shed (for shed read vehicular temporary storage area- non garden bottom orientated-ie i save it in the MG) a partial outer inner wing, brand new. So, i thought i would need all these parts before removing the wing.

The great god Mr Mark Evans says its important to repair the inner wing BEFORE removing the outer................................please forgive the petulance and disobediance Mr Mark ,but you're wrong ! Especially since you don't know MY CAR, previously bodged..big time.
Below is a prime example. Look at said wing removed.

This is the removed wing. Its had a repair panel "sort of " welded aroung the wheel arch. I say sort of since the norm is to replace all of the lower half at the seam/swage line, or joddle a new section/s under the damaged/cleaned up wheel arch. This was neither, just lots of filler over the whole area right down to the rear valance and rear light cluster ( including much gauze below the light cluster) The panel was a doddle to remove for 2/3rds of its connection . The final 1/3rd was a right swine, its the part thats nearest the rear door gap. The actual wing fits over some areas of gently bent ( 90 degree bend with lovely radius) and fits under other areas, all making a nice join at the point you notice most when opening the door. I took me ages to discover the tiny spotwelds, some inaccessible, some invisible most impossible. Surely it did not take this long to remove the other side.,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,,!!!!!!No yer great clot!!!!

You bought the car with no rear left wing, remember, all that time long ago, when you were blissfully ignorant of bleeding knuckles, eyes full of grit, pores full of Duckhams and a shed you could actually walk into. So a few gentle taps with the omni tool ( part chisel/part screwdriver/part upholsery prise bar/part rust basher/scraper) some sardine can like peeling with the water pump pliers after a slicing sesion with trusty grinder ( + slicing disc) and yipee.

Tried to work today ( Saturday 2 pm) but despite the sun shining its bloody cold. Only managed to dress up some rusty edges on wing before my toes and nose said no more please. Spent most of following Sunday catching up with college, its still freezing cold out though.




Next job on the list is to Purchase and fit outer sill. Make and weld small tabs to secure A post to sill.
Then remove rust from wheel arch HERE <
Fit new wheelarch repair panel. Weld to rear of new sill.
Fit new wing and weld then repair base of rear light/pointy thing and join with rear valance.

Should keep me happy for a bit, if it don't rain !