A little bit more progress

So whats been happening then !
I booked 3 days leave from work to ferry the kids back to Uni with a weekend sandwiched in between, so 5 whole days. It transpires as 3 actually as 2 days were for above, one day it p***ed it down, the other day it rained p.m as I was in town in the a.m. So that left One day ! on which to get more progress.
I did though.
Firstly found LH winder mechanism in shed. The LH door glass was next together with mounting screws and winder handle.
Found front LH Indicator lens and frame in shed.
Found front bumper in loft and brackets in conservatory under a pile of wifeys artyfarty stuff.
Found LH quarter light assy in shed.

One thing that did puzzle me was...........I bought a pair of doors ( from you know where) about 4 years ago. Turned out they were crap, rusty, full of filler and poor lock chrome. However the quaterlights were good so I saved them down by the shed wrapped in polythene.
When it came time to find the LH door/window stuff I'm sure I had 3 RH side windows, quarterlights and winders !!
It took forever to figure out what was what and for which side.
Coo....the winder mechanism drove me nuts as I had four of them and trying to decide which way round they went was baffling.
Anyways, I cleaned up said winder mechanism with thinners,wire wool,soapy water and lithium based grease and fitted. Trouble is though the door is now heavier and its a swine to re-align and tighten the 6 door screws sufficiently so it does not drop.
Anyone got any Ideas better than the 6 Phillips screws used ?

Not thwarted I attached the quarterlights roughly. The top edge of the quarterlight seems a long way from the windscreen A pillar...eek.

N

Not quite shown in the picture due to the slight head on angle and I had a little jiggle around with the door.

I must admit that its good to be finally fitting stuff on rather than taking stuff off or even sanding.

I also have 4 window channel runners but think I've found out which way they fit..hopefully. Trouble is though I can't find the base bracket I fabricated a few years ago to hold it in position on the door bottom. I desperately need a selection of UNC/F nuts, bolts, screws/washers. MGB Hive do one for £18 ore so, so next payday will see me purchase one. I also need some to hold the front bumper to its brackets whilst I drill holes in the chassis rail.

That brings me to my next job.

Courtesy of the Canadian MGB register and Moss USA, I found the templates to weld up the indicator holes from the front ( Rubber) bumper position and new hole position to suit the chrome bumper light ( Yes I know its getting boring...another E-bay purchase, albeit 5 years ago).

So set to I did with 2 new in-fill pieces for LH & RH sides. Scrounged B & D jigsaw from Ma-in-law ( only wood blades available but hey ho it worked).

Picture to follow